LED light plate for Talmu Daylamps, Matronics

Large and powerful emitter that fits in the original Hella Talmu DRL lamps.** This creates a strong and bright light throughout the lamp. Available for 12V or 24V, in various combinations of two colors.

The original reflector is removed and the emitter is placed directly inside. 4 rubber washers are used to hold the emitter in place. There is a 10 cm wire on the back to connect it to power.

Two colors

The two-color model has 3 wires, a common ground and a plus for each color. This is usually connected to a toggle switch or relay for color change.

Two colors + flash

The standard strobe color is yellow, but it can be customized to e.g. blue or white for special vehicles. The 12V model has 3 high-performance strobe LEDs, while the 24V has 6.

There is a 7-meter cable on the emitter with M8 connectors that can be connected to the included controller. The controller controls the two colors and automatically turns them off when the strobe light is activated. The controller has a 5-meter cable. The cable has 4 wires:

- Negative - Green cable
- Plus for white position light - White cable
- Positive for yellow position light - Yellow cable
- Plus for strobe light - Brown cable

Price for 1 piece.

Diffusers

The diffuser gives the light a neon look, where it is not possible to see the individual LEDs on the circuit board. The diffuser only fits our LED emitters.

The diffuser is made of a frosted plate and two springs. The glass is removed from the lamp and the two springs are placed over the two screw bosses. The diffuser is then placed on top and the lamp is closed.